RESISTRON CIRUS

  • Stainless steel heating elements mounted on bar body with spring loaded tensioning
  • Different types of hard and soft backing materials available
  • Monolithic sealing tool with printed heating surface
  • Hard surface directly on stainless steel substrate

Heated tool (bottom) can be combined with
  • passive tool (left)
  • heated tool (middle)
  • different silicone profiles (right)
Heated tool (bottom) can be combined with
  • passive tool
  • different silicone profiles
For further information about silicone profiles please see silicone retainers

Very fast heat up when compared to constant heat
Heat up times vary between different applications
Very fast heat up when compared to RESISTRON

  • Water cooling optional
  • Single and both sided heat commonly used
  • Water cooling mandatory
  • Typically only single sided heat, both sided possible in some cases
Various heating element shapes available

Typical flat and tapered bands are 3 to 8 mm wide, other dimensions are possible
The typical thickness is 0,1 to 0,3 mm
Typical applications use a length in the range of 10 to 3000 mm, special applications exceed this range

For common shapes and sizes please see Overview over common bands		 Heating element is flat

Standard heating elements are available with nominal width of 2,8 / 4,8 / 6 mm
Available length for standard heating elements is 200 / 250 / 300 / 350 / 400 / 450 / 500 / 600 / 700 / 800 / 900 / 1000 mm


Contours are possible
Contours are possible